ball joint rod end bearing process

- Mar 16, 2018-

Ball joint rod end bearing is a spherical plain bearing. Its basic type is composed of inner and outer rings with a spherical sliding spherical contact surface. The ball joint rod end bearing is mainly composed of an inner ring with an outer spherical surface and an inner spherical surface. The outer ring is composed of a large load.

The different types and structures of the ball joint rod end bearing during operation can tolerate radial load, axial load or combined load of radial and axial simultaneous existence to some extent. Due to the composite material embedded on the outer sphere of the inner ring, the bearing can be self-lubricating during operation.

Ball joint rod end bearings can be effectively used for low-speed swing motions in general, so that the device can also perform tilting motion within a certain range of angles. When the bearing shaft and the shaft housing hole have different degrees of misalignment, Can work normally. Self-lubrication joints are used in water conservancy, professional machinery and other industries.

Ball joint rod end bearings have a large spherical sliding contact area and a large angle of inclination. At the same time, most joint bearings use special processing methods such as surface phosphatizing, galvanizing, chrome plating or sliding surface lining, and inserts. Mats, spraying, etc. Therefore, it has a large load capacity and impact resistance, and has the characteristics of corrosion resistance, wear resistance, self-aligning, good lubrication or self-lubricating non-lubricant dirt contamination, even if the installation is misplaced, it can work normally.

Ball joint rod end bearings and rod end joint bearings have a variety of designs and have different combinations of sliding contact surfaces. Each design and combination has unique properties that make it particularly suitable for certain applications.