Installation and disassembly of PTFE Lined Metric Rod End Bearings and standard requirements

- Mar 25, 2019 -

The PTFE Lined Metric Rod End Bearings is very sensitive to the damage of the rod end joint bearing when it is used. In the operation, such as its peeling, indentation, rust, crack, wear, etc., it will be in the vibration measurement of the rod end joint bearing. It is reflected, so the vibration can be measured by using a special rod end joint bearing vibration measuring device (frequency analyzer, etc.), and the specific situation of the abnormality cannot be inferred by the frequency division. The measured value differs depending on the conditions of use of the rod end joint bearing or the position at which the sensor is mounted. Therefore, it is necessary to analyze and compare the measured values of each machine in advance to determine the judgment standard.

 

Installation and disassembly of PTFE-lined metric rod ends

 

1. Regular maintenance of PTFE-lined metric rod end bearing: In order to ensure the normal operation of the main machine during operation, it will effectively set a maintenance cycle and regular maintenance according to the request of the mainframe and the theory and application experience of the bearing design. .

 

2. Trouble-shooting: When the bearing is in trouble, stop the inspection and repair.

 

3. Early warning maintenance: Apply advanced bearing fault diagnosis technology, stop real-time monitoring of bearing operation status, and make advance notice before the bearing attack, stop maintenance.


http://www.wxjwbearing.com