Swivel ball joint rod end installation and attention requirements

- Dec 03, 2018-

Where the Swivel ball joint rod end  is lacking and unable to use the press, the assembly sleeve and the small hammer can be used to install the end rod joint bearing during operation, and the hammering force should be evenly transmitted to the entire end face of the end rod joint bearing ring. On the circumference, the end face of the assembled casing that is hammered should be made spherical.

When the Swivel ball joint rod end  is installed, the required force is related to the size of the joint bearing and the amount of interference. For medium or large joint bearings with large interference, the hot charging method is commonly used. Before hot loading, put the end rod joint bearing or the separable joint bearing ring into the fuel tank or special heater and heat evenly to 80-100 °C, not more than 100 °C.

The hot-fitted joint bearing of the Swivel ball joint rod end  requires skillful operation skills to a certain extent. After the product is taken out from the heating tank or the heater, the oil track and the surface of the joint bearing surface should be wiped off immediately with a clean cloth. Object (note that cotton yarn cannot be used), then place it in front of the mating surface and push the joint bearing against the shoulder in one operation. Always tighten during the cooling process or tap the joint bearing with a small hammer through the fitting sleeve to make it tight. When installing the end rod joint bearing, the joint bearing should be slightly rotated to avoid the installation from tipping or jamming.

 

http://www.wxjwbearing.com